Jilin Changchun factory direct 10kv insulation rubber sheet 5mm thick, GB red insulation plastic sheet

Shenyang Yuante Rubber & Plastics Co., Ltd. is a company specializing in the production and sales of rubber and plastic products. Since the establishment of the company, we have strictly controlled product quality and gradually realized various modern management systems. It is China's production of high and low pressure rubber pipes, large diameter hoses, Rubber plate, rubber soft joints and other rubber products professional manufacturers. Buy plastic board to find far special

Insulating rubber sheet introduction

Insulating rubber sheets, also known as insulating blankets, insulating mats, insulating sheets, insulating pads, insulating rubber pads, etc., have large volume resistivity and resistance to electrical breakdown. Mesa or floor insulation for work places such as power distribution. Physical and mechanical properties are good, with excellent insulation properties, can work in the environment of dry -35 ~ 100 °C air requirements for high dielectric constant. Through the 43KV test, it works normally at 660V . Strong elasticity, excellent insulation properties , shiny surface.

Insulation rubber sheet features

Physical and mechanical properties are good, with excellent insulation properties, can work in a dry -35 ~ +100 °C air medium demand high working environment. Through the 43KV test, it works normally at 660V. Strong elasticity, superior insulation properties, shiny surface. Widely used in substations, power plants, power distribution rooms, laboratories, and field live work.

Uses and storage methods

It is suitable for the laying of worktables and grounds for electronic sites, laying and installation of grounds for power stations and substations;

Should be stored in a dry and ventilated environment, away from heat sources, away from the ground [and wall more than 20cm. Avoid contamination with acids, alkalis, and oils. Do not expose it outdoors to direct sunlight.

Selection configuration table

The use of different voltage levels of the environment should use different thickness of insulating plastic sheet.

Electrical insulation test

Pad thickness

Frequency withstand voltage test requires time

Power frequency withstand test standard value

Power frequency withstand test test time

Power frequency withstand test experimental value

10KV

5mm

1 minute

10KV

2 minutes

≥15KV

15KV

6mm

1 minute

10KV

2 minutes

≥15KV

25KV

8mm

1 minute

25KV

2 minutes

≥30KV

35KV

10mm

1 minute

35KV

2 minutes

≥35KV

35KV

12mm

1 minute

35KV

2 minutes

≥35KV

Screw chip  conveyor classification

1. If the length of U-shaped Screw Chip Conveyor is less than 35m, it is a single-axis driving screw.

2. If the length of U-shaped screw Chip Conveyor is greater than 35m, it is a two-axis driving screw.

3. Ordinary carbon steel U-shaped screw chip conveyors - Mainly used in industries where cement, coal, stone, etc. wear out, and there are no special requirements for materials.

4.Stainless steel U-shaped screw chip conveyor - mainly applicable to food, chemical, food and other industries that have requirements for the delivery environment, cleanliness, and will not produce pollution on the material, the use of a long time, but the relatively high cost.

screw type chip conveyor


Screw Type Chip Conveyor

Screw Type Chip Conveyor,Screw Chip Conveyor,Screw Conveyor,Screw Conveyor Design

Cangzhou Dongjun Machinery Accessories Co., Ltd. , https://www.cablechainfactory.com