Die Cutting Machine is also known as a beer
machine and CNC punching machine, it is mainly used for the corresponding
non-metallic materials, sticker, EVA, double-sided adhesive, electronics,
mobile phones, pads and other die-cut (full cut or kiss cut), the indentation and
bronzing job fit, automatic waste discharge, die-cutting machines use blades,
metal molds, steel wire (or steel plates carved into the template) to apply
some pressure by stamping version, printed materials or cardboard rolled and
cut into a certain shape. Cutting machines are very important equipment in the
post press packaging molding process.
Die-cutting Machine Working Principle
Die Cutting Machine Die Cutter,Die Machine,Die Cutting Machine,Electric Die Cutting Machine Suzhou Flying Man Assembly Automation Co., Ltd. , https://www.flyingmancuttingmachine.com
Working principle of die cutting machine is to use the steel knife, metal molds, steel wire (or steel plate engraving templates), the pressure applied by embossing version, make the printed materials or cardboard rolled and cut into a certain shape. If the pressure of the entire printed materials cut into a single graphics products, this is called die-cutting; if use the two templates of upper and lower by the mold to heat up to a certain temperature, to leave the bending groove marks is called indentation on the surface of the printed products stamping having a three-dimensional effect of the pattern, or font called bronzing; if use a substrate to multiplex on another substrate, this is called bonded; excluded from inter authentic outside the remaining portion of said above collectively referred to as die-cutting technology for waste; the working principle of the automatic die cutting machine is the feeding machine feeder parts sent the paper to the front and the regulatory and side provisions bit, and then the tooth row send the paper to the die secondary positioning for cutting, after die-cutting and then again from teeth row to the platoon served stripping agencies, after stripping and then enter the delivery section, thus completing a die-cutting job.
Lord launches new acrylate adhesive for various substrates
Lord has introduced a new type of acrylate adhesive, MaxlokTM, which is specially used for bonding all types of substrates. The adhesive is strong, does not peel off, and enhances the adhesive performance when the adhesive surface is opened and closed. The product is designed with the widest range of applicable properties in mind, and offers three cure rates (each containing glass beads to ensure optimum thickness), while different cure rates can be assigned to different seasons, Different temperature and humidity operating environment, and its sizing ability is better. The adhesive is gray (matched to most metals) and its applicable temperature is -40-149°C, meeting the high application requirements of transportation, wind energy, solar energy, shipping, special buildings and RV/special vehicle industries. The overall performance of this adhesive is better than similar products and traditional mechanical fastening products, and it is excellent in bonding various substrates (especially galvanized steel), and the adhesive does not need to use primer, high bonding strength, and Time, effort and lower cost; compared with similar products, the adhesive is more advantageous in environmental resistance, salt spray resistance and humidity resistance. In addition, the adhesive is also effective against attack by dilute acids, dilute alkalis, solvents, greases, oils, moisture, salt spray, weathering, etc., and has excellent UV resistance.