Procedures of operating I. Before using the equipment, to check if the equipment is flat and level, to make four angles of the equipment are in one level. II. Make sure all the screws are fixed. III. The two angle irons which are to adjust the middle set of feeding frame should be equal in two sides of the middle line of equipment. If it is pulling to one side, that is, the two sides of finished product is different. In this case, you need to adjust the front striker plate. Then to check with a piece of steel sheet, if it`s not OK, adjust again. And the best way is to make the left striker plate be adjusted with the right one. After the adjustment, fix the striker plate. IV. Daubing grease on chain and chain wheel to protect them from wear and tear. V. If the equipment is pulling to one side during the process, you can just adjust the two angle irons on the feeding platform. VI. Suitable thickness of the processed plate is with 0.3mm-0.8mm, and the productivity is 10m/min. VII. Trouble shooting. During processing, if there appears any trouble such as paint rubbing, please carefully to find out where the trouble appears. After that, to polish the mold with abrasive brick.glazing machine or emery cloth, and daub engine oil on it. This phenomenon is because the mold discharges in chromium plating. This should be find and solve in time during processing.