LED advertising publicity vehicle daily maintenance and maintenance

As a new era of multimedia advertising tools, LED advertising publicity vehicles are now receiving more and more platforms and attention. At the same time, the maintenance and maintenance of LED publicity vehicles has become more and more attention! In our daily use process, how to properly maintain and maintain is an indispensable knowledge of using LED advertising vehicles. The propaganda vehicle manufacturers bring you some propaganda knowledge. Welcome everyone to pay attention to consultation!

微信图片_20190114150552 (2).jpg

I. Chassis maintenance and maintenance of LED advertising vehicle:

    When we use the vehicle, if we often drive the vehicle to the streets to promote the promotion of the publicity vehicle, we must maintain it in accordance with the vehicle chassis warranty manual. The vehicle oil and filter element must be replaced every 5000 km to 6000 km, about 25,000 km Replace the brake discs and regularly check the antifreeze and water tank, which can make the car better. According to the actual use of the vehicle, you can maintain it according to the situation!

微信图片_20190121165145.jpg

Screen maintenance and maintenance of LED advertising vehicle:

Although the high-definition outdoor full-color waterproof screen used in the propaganda car is waterproof and leakproof, it will be exposed to the wind and exposed to the sun for a long time. It may also be damaged after being too long! When we do not often use LED publicity vehicles, we need to perform a power cycle on the entire vehicle screen every ten days or so to prevent the static damage of our screen plate. The activation of the interval time period will also extend the screen life! In particular, if the screen is too dirty, we can also wipe the screen surface with a rag, but we must not wipe the screen directly with a high-pressure water gun or similar tools!

微信图片_20191125112348 (2).jpg

Third, the LED board advertising car maintenance and maintenance:

The screen of the advertising car is made by splicing plates and lines, and there will be a gap in the middle to dust, and dust may cause short-circuit damage to the screen! We must open the screen control box about a month to clean up the internal dust. You can use the high-pressure air pump of the maintenance station to clean up the dust inside. You can also use a dry cloth to wipe. Pay special attention to the cloth , Be sure to turn off the vehicle's power, be sure to turn off the vehicle's power, and then turn off the vehicle's power!


微信图片_20190917105549 (2).jpg

4. Maintenance and maintenance of generators for LED advertising vehicles:

The generator used in the propaganda car is an independent system. There is a distinction between diesel and gasoline according to the size of the vehicle and the screen area, but both require regular maintenance! We recommend that the generator be replaced with an oil every three months to ensure the working state of the generator. Check the generator water tank at intervals of about half a month, depending on your own use!

微信图片_20180619113641.jpg

V. Lifting Maintenance and Maintenance of LED Advertising Car:

Some customers have installed a screen lift when they bought an advertising car. If we feel that the screen lift has a foreign body sensation or that the screen lift is not smooth during daily use, we must clean and inspect the screen lift Occasionally, it is necessary to oil the screen lifter to prevent damage to the lifter. The maintenance time is based on no fixed time, depending on the situation, but it must not be ignored!

Want to know more about the models and knowledge of LED advertising vehicles, please call the LED advertising vehicle manufacturers hotline

微信图片_20190509122348.jpg

Follow the LED advertising car manufacturers to learn more about the car models and knowledge:

Workshop Direct Hotline: 177-7176-5556 (same WeChat) 189-9596-1101 Yang Shujia

High Qualtiy, High cutting Performance, High Precision CNC Wire Cutting EDM Machine. China leading manufacturers and suppliers of CNC Wire Cut EDM Machine, EDM Machine , and we are specialize in Wire Cutting EDM Machine, etc.

wire cutting edm machine

CNC Wire Cut EDM Machine

CNC Wire Cut EDM Machine,EDM Machine,Wire Cutting EDM Machine,CNC Wire Cut

Suzhou Simos CNC Technology Co., Ltd. , http://www.edm-machines.com