2. Test the gas into the tank to see where the water from the tank is seeping when it is pressurized, and then decide on a remediation plan. 3. Unscrew the lid of engine plus oil to see traces of inorganic oil emulsification (punch or corrosion phenomenon). If so, disassemble the engine and replace the cylinder head gasket. 4. There is a problem with the quality of the water tank. If the car is in the process of driving, due to vehicle vibration or vehicle accident, if the tank water pipe ruptures and leaks, measures can be taken according to specific conditions: When the water leakage does not exceed 1mm crack or 2mm hole, add a bottle of water tank blocking agent to the tank to start the car. 5~10 minutes after the cooling water is turned on, the cooling system will be leaking at the leaking water (or antifreeze) regardless of whether it is a water tank or a rubber pipe and all mats. The leak will not be released after the leak is stopped, and the heat dissipation will not be affected. Blockage occurs. If there is no anti-leakage agent to carry, if the individual heat pipe leaks lightly, put the loose tobacco into the water tank temporarily and use the circulating pressure of the water to make the tobacco block plugged in the leaking part of the heat pipe and temporarily use it. For water tank cooling pipe leakage is more serious, you can cut the leaky heat pipe from the leak, with a soap coated cotton mass cut off the heat pipe, and then use the pliers to cut flat heat pipe head flattened and then crimped Press tight to stop leaking. If the rubber pipe joint leaks, use a screwdriver to wrap the rubber pipe joint clamp in the rubber pipe joint and then tighten it with the pliers. If the rubber tube is damaged, use a tape to wrap it tightly and temporarily use it. Centrifugal Pump,Polyvinyl Butyral,Frp Horizontal Centrifugal Pump,FRP pump submersible pump Sewage pump,Water pump Co., Ltd. , http://www.nbagriculturalpump.com
Water tank leakage causes and treatment methods
1. Check that the tank lid is fastened.